SORHEA SHOCK DECTECTION G-FENCE 3000

G-FENCE is a shock detection system for perimeter fences. G-FENCE detects fence vibrations generated by intrusion attempts by cutting, climbing or pulling out the fence. The system then transmits alarm information via the MAXIBUS 3000 Hub.
To limit civil engineering, G-FENCE works autonomously thanks to power supply from solar panels and a batteries that are integrated into each control unit. Unique on the market, the G-FENCE innovation can be used to secure a 3200 m x 4 perimeter while guaranteeing a 1 second alarm response time and a precise intrusion location to within 3 m.
Detection adjustment is very simple. A mapping software application is used to locate zoning by superimposing it over a site plan or picture. Maintenance is facilitated as the product is easy to connect.

APPLICATIONS
With its 3200 m of detection per system, G-FENCE is ideal for securing long perimeters. Compatible with all “meshed” fences, the detector cable and its equipment are easy to install on the support and can be easily replaced if the cable is cut during an aggression.

Thanks to the system’s autonomy, civil engineering operations are also limited, and the system can be used on any sensitive site configurations: oil refineries, nuclear power plants, airports, etc., but, above all, on sites where it is not possible to have an electrical power supply at the perimeter fence.

RECOMMENDATIONS FOR INSTALLATION
It is important to install a detector cable in the middle of the fence with the supplied cable clamps, and to fix a sensor by tightening one of the cable clamps on the fence mesh joint. To optimise the sensor’s detection, the sensor must be placed in the middle of the fence panel.

Do not install the Control Unit in front of a hedge or in a shaded area, to avoid covering the solar panel. The CU may be used remotely if necessary.

Entrances and Gates: use at least a 0.6mm² standard cross-section cable with a maximum length of 50 m per detector cable.